8.12 Logging In to the FusionDirector WebUI
Operation Scenario
Use Google Chrome to log in to the FusionDirector WebUI. On the FusionDirector
WebUI, you can manage chassis components and cluster devices.
Prerequisites
Conditions
● Google Chrome 55 or later is required for logging in to FusionDirector.
● You have obtained the IP address, username, and password of FusionDirector.
The default username of the FusionDirector WebUI is Administrator, and the
password is Admin@9000.
● If you log in as an LDAP domain user, ensure that the LDAP server
communicates with FusionDirector properly, the LDAP function has been
enabled on FusionDirector, and the LDAP server and user group information
has been
congured.
● If you use the DNS domain name to log in, ensure that the DNS server
communicates with FusionDirector properly and the domain name and DNS
server are
congured on FusionDirector.
Precautions
● FusionDirector supports a maximum of 100 concurrent users.
● The default timeout interval of FusionDirector is 30 minutes. If you do not
perform any operation on the WebUI within 30 minutes, the account is
automatically logged out. You need to enter the username and password to
log in again.
● If the number of login failures caused by incorrect user names and passwords
reaches the value
specied in the system security policy, the account is
automatically locked. When the lockout duration reaches the value
specied
in the security policy, the user is automatically unlocked.
● To ensure system security, change the default password upon the rst login
and change the password periodically.
Procedure
Step 1 Connect the Ethernet port of the PC to a management network port of the active
or standby MM920/MM921 over the LAN.
The 10GE optical port and MGMT port on the MM920/MM921 panel are
management network ports. This section uses the MGMT port as an example.
Figure 8-32 shows the network connections.
Huawei Servers
Troubleshooting 8 Common Operations
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 154