Huawei E9000 - Page 164

Figure 8-32 Network connections
Step 2 Set an IP address and a subnet mask or add route information for the PC so that
the PC can communicate with FusionDirector.
Step 3 Open the browser, enter https://
ipaddr in the address box, and press Enter.
NO TE
● ipaddr indicates the address used to access the FusionDirector WebUI. It can be in either
of the following formats:
– IPv4 address in dotted-decimal format XXX.XXX.XXX.XXX .
– Fully
qualied domain name (FQDN) of FusionDirector.
● The browser may display a message indicating that the website has a security certicate
error. Ignore this error and continue the login if the IP address is correct.
Step 4 Enter the login information.
Table 8-5 describes the information required on the login page.
Huawei Servers
Troubleshooting 8 Common Operations
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 155