----End
4.4.2.6 Using the Switch Module CLI to Collect FC Switching Plane
Information (MX510)
Operation Scenario
Use the CLI of a switch module (MX510) to collect FC switching plane information.
This section applies to the CX311, CX911, and CX915.
Prerequisites
Conditions
● The PC has been connected to the management network port of the server by
using a network cable.
● The mini-sftp-server.exe software has been obtained.
If the MX510 rmware version is earlier than 9.8.2.6.0, you can use the FTP tool WFTPD to
collect information. For details, see 8.20 Conguring an FTP Server.
Data
Table 4-8 Data list
Parameter
Example Value
IP address 192.168.1.100
Subnet mask 255.255.255.0
Default gateway 0.0.0.0
The default username of the switching plane is admin, and the default password
is Huawei12#$.
Software Tools
mini-sftp-server.exe: used to transfer
les between dierent platforms, for
example, from a switch module to a PC. This tool is third-party software. You need
to prepare it by yourself.
Procedure
Step 1
Congure an SFTP server.
For details, see 8.21 Using SFTP to Transfer Files.
Step 2 Log in to the MX510.
For details about how to access the FC switching plane CLI, see 8.15 Logging In
to a Server Over a Network Port by Using PuTTY or 8.17 Logging In to a
Huawei Servers
Troubleshooting 4 Collecting Information
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 30
To Next Page
Loading...
