Huawei E9000 - Querying the Software Version of the Ethernet Switching Plane

Example: Administrator@SMM:/#ipmcset -l swi2 -d ipaddr -v 172.200.2.153
255.255.0.0 172.200.0.1
----End
4.4.1.2 Querying the Software Version of the Ethernet Switching Plane
Query the software version of the switching plane before upgrading a switch
module.
Prerequisites
● The switch modules have been powered on.
● For logging in to the Ethernet switching plane over SSH, the default username
is root and the default password is Huawei12#$.
● By default, the MM910 username is root and the password is Huawei12#$.
● You are familiar with the parameters required for this operation.
Table 4-3 Parameter description
Parameter Example Value
IP address and subnet mask of the
management network port on the
Ethernet switching plane
● IP address of the management
network port: 192.168.9.61
● Subnet mask: 255.255.255.0
Floating IP address, subnet mask,
and gateway of the MM910
● IP address: 10.85.4.77
● Subnet mask: 255.255.255.0
● Gateway: 10.85.4.1
Procedure
Step 1 Connect the PC to the Ethernet switching plane.
For details, see 4.4.1.1 Connecting a PC to the Ethernet Switching Plane.
Step 2 Log in to the CLI of the Ethernet switching plane by using the SOL function of the
MM910.
For details about SOL login, see 8.17 Logging In to a Compute Node,
Passthrough Module, or Switch Module by Using the SOL Function of the
MM910.
Step 3 Run the following command to query the version of the Ethernet switching plane:
display version
● Information similar to the following is displayed:
BoardName : CX910
CPLD Version : 003
PCB Version : VER.A
Bootrom Version : 008
Creation Time : Sep 17 2012, 09:53:25
Backup Bootrom Version : 008
Huawei Servers
Troubleshooting 4 Collecting Information
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 17