Huawei E9000 - Technical Specifications

Table 5-2 Methods for handling alarms
Server Type Reference
E9000 See the FusionServer Pro E9000 Server V100R001 HMM
Alarm Handling .
To check switch module alarms, run the following
commands on the Ethernet switching plane:
● display trapbuer
● display alarm active
● display alarm history
NOTE
For details about how to log in to the Ethernet switching plane of
a switch module, see 8.15 Logging In to a Server Over a
Network Port by Using PuTTY, 8.16 Logging In to a Server Over
a Serial Port by Using PuTTY, or 8.17 Logging In to a Compute
Node, Passthrough Module, or Switch Module by Using the SOL
Function of the MM910.
E6000 See the E6000 Server V100R002 Alarm Reference .
V2 rack servers See the Huawei Rack Server Alarm Handling (iMana
200) .
V2/V3/V5 rack
servers
See the FusionServer Pro Rack Server iBMC Alarm
Handling .
X6000 See the FusionServer Pro X6000 Server iBMC (Earlier
than V250) Alarm Handling or X6000 Server Alarm
Handling (iMana 200) .
X8000 See the X8000 Server V100R001 Alarm Reference .
X6800 See the FusionServer Pro X6800 Server iBMC (Earlier
than V250) Alarm Handling .
G2500 See the FusionServer Pro G2500 Server 1.0.0 iBMC Alarm
Handling .
FusionServer Pro
G5500
See the FusionServer Pro G5500 Server iBMC Alarm
Handling .
Atlas 800 AI
inference server
(model 3010)
See the Atlas 800 AI Inference Server iBMC Alarm
Handling (Model 3010) .
Atlas 800 AI
training server
(model 9010)
See the Atlas 800 AI Training Server iBMC (V3.01.00.00
or Later) Alarm Handling (Model 9010) .
5.4 Using Error Codes to Locate Faults
The following servers support the fault diagnosis LED: RH1288 V3, RH2288 V3,
RH2288H V3, RH5885 V3, 5288 V3, 1288H V5, 2288 V5, 2288H V5, 2488 V5,
Huawei Servers
Troubleshooting 5 Diagnosing and Rectifying Faults
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 40