EasyManua.ls Logo

Huawei E9000 - Power Supply System

Huawei E9000
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 3 (Optional) Run the following command to query the IP address of the
management network port of the Ethernet switching plane:
smmget -l swi
N
:fru
M
-d
swipcontrol
The parameters are described as follows:
N
indicates the slot number of the switch module. The value range is 1 to 4,
mapping to logical slot numbers 1E, 2X, 3X, and 4E from left to right on the
panel respectively.
M
: indicates the ID of the switching plane. The value for the Ethernet
switching plane is 2.
Check whether the IP address is 0.0.0.0.
If yes, go to Step 4.
If no, go to Step 5.
Step 4 (Optional) Run the following command to set an IP address for the management
network port of the Ethernet switching plane:
ipmcset -l
<bladeN|swiN>
-d ipaddr -v
<ipaddr> <mask> [gateway]
The parameters are described as follows:
N
indicates the slot number of the switch module. The value range is 1 to 4,
mapping to logical slot numbers 1E, 2X, 3X, and 4E from left to right on the
panel respectively.
M
: indicates the ID of the switching plane. The value for the Ethernet
switching plane is 2.
ipaddress
: indicates the IP address of the management network port.
maskaddress
: indicates the subnet mask of the management network port.
Step 5 (Optional)
Congure the gateway for the switching plane by running the
following command so that the switching plane can communicate with the PC:
NO TE
For stacked switching planes, congure the gateway only for the master switching plane.
smmset -l swi
N
:fru
M
-d route -v
targetvalue maskvalue gatewayvalue
The parameters are described as follows:
N
indicates the slot number of the switch module. The value range is 1 to 4,
mapping to logical slot numbers 1E, 2X, 3X, and 4E from left to right on the
panel respectively.
M
: indicates the ID of the switching plane. The value for the Ethernet
switching plane is 2.
targetvalue
: indicates the target network segment IP address of the switching
plane.
maskvalue
: indicates the subnet mask of the switching plane.
gatewayvalue
: indicates the gateway IP address of the switching plane.
Huawei Servers
Troubleshooting 4 Collecting Information
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 16

Table of Contents

Other manuals for Huawei E9000

Related product manuals