● The encoding indicator is steady on. Press the number keys to enter the address code to
be encoded, and then press the Run/Stop key to encode the address code.
● After the encoding is successful, the address code is displayed on the screen, and the
buzzer sounds once.
● If the encoding fails, the screen blinks
, and the buzzer sounds three times. In this
case, check that the cable connection and terminal type are correct, and then perform
the encoding again.
● If an incorrect address is entered, press Delete to delete the address and enter the
address to be encoded again.
Step 3 On the screen of the re alarm control panel, choose Operation > Auto Login to
register the preset address code in the re alarm control panel.
Step 4 Choose Bus Setting > Detector/Module Setting, and check that the device types
of the gas release indicator,
re alarm horn/strobe, and input/output module
correspond to the gas release indicator, indoor re alarm horn/strobe, and outdoor
re alarm horn/strobe respectively. If not, select the correct device type from the
drop-down list box.
Step 5 Disconnect cables from the electromagnetic valve.
Figure 5-1 Disconnecting cables from the electromagnetic valve
Step 6 Switch on the active and standby power supplies to the re alarm control panel.
Step 7 Check whether the re alarm control panel displays any alarm. If an alarm is
displayed, clear the alarm before performing follow-up operations.
Step 8 Press Keyboard and enter the password (the initial password is 111111) to unlock
the keyboard. Then press Auto/Manual to set the
re alarm control panel to the
Auto mode.
FusionDC1000A Prefabricated All-in-One Data
Center
Commissioning Guide (IT Scenario) 5 System Commissioning
Issue 02 (2022-12-15) Copyright © Huawei Digital Power Technologies Co., Ltd. 67
To Next Page
Loading...
