Huawei FusionServer Pro XH321 V5 - Page 54

Figure 8-3 Removing the multi-port cable
Step 4 Remove the optical cables and modules.
NO TICE
● Replacing the optical cable, network cable, or optical module will interrupt
services.
● Wear ESD gloves or an ESD wrist strap when using die-casting pliers to replace
optical or network cables or optical modules.
● Do not exert too much force when using the die-casting pliers to prevent
damage to the optical or network cables or optical modules.
1. Use the die-casting pliers to clamp the optical cable connector and remove it
from the port.
Figure 8-4 Removing optical cables using die-casting pliers
2. Use the die-casting pliers to clamp the optical module, unlock the security
pin, and remove the optical module.
FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide 8 Parts Replacement
Issue 17 (2021-03-09) Copyright © Huawei Technologies Co., Ltd. 45