Figure 8-5 Removing an optical module using die-casting pliers
Step 5 Remove the server node.
● When removing a device, wear protective gloves to avoid burns.
● To prevent device damage or personal injury, hold the bottom of the device
with both hands when removing it.
1. Press the ejector release button on the server node. See (1) in Figure 8-6.
2. Fully open the ejector lever. See (2) in Figure 8-6.
3. Holding the ejector lever, pull the server node out of the chassis horizontally.
See (3) in Figure 8-6.
4. Close the ejector lever.
Figure 8-6 Removing the server node
Step 6 Place the removed server node in an ESD bag.
FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide 8 Parts Replacement
Issue 17 (2021-03-09) Copyright © Huawei Technologies Co., Ltd. 46
To Next Page
Loading...
