Figure 8-24 Positions and slots of the M.2 FRUs
Step 2 Remove the M.2 FRU from the Avago SAS3004iMR RAID controller card.
1. Open the handle of the M.2 FRU. See (1) in Figure 8-25.
2. Remove the M.2 FRU. See (2) in Figure 8-25.
Figure 8-25 Removing an M.2 FRU
Step 3 Place the removed component in an ESD bag.
Place only one component in an ESD bag.
Step 4 Install an M.2 FRU ller module to shield the EMC.
Perform this step only when an M.2 FRU is not installed immediately.
----End
FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide 8 Parts Replacement
Issue 17 (2021-03-09) Copyright © Huawei Technologies Co., Ltd. 63
To Next Page
Loading...
