Figure 8-31 Removing a processor (1)
2. Hold the two sides of the processor and lift it.
Figure 8-32 Removing a processor (2)
Step 8 Place the removed component in an ESD bag.
● Clean the thermal compound of the removed processor and put it into an ESD bag.
● Place only one component in an ESD bag.
Step 9 Install a processor socket cover.
● Perform this operation only when a processor is not installed immediately.
● The processor socket cannot be exposed and must be covered by a processor or cover
during transportation and storage.
1. Aligning the processor socket cover with the guide pin on the processor
socket, place the cover on the processor socket. See (1) in Figure 8-33.
2. Press the positions shown by (2) in Figure 8-33 until you hear a click.
FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide 8 Parts Replacement
Issue 17 (2021-03-09) Copyright © Huawei Technologies Co., Ltd. 68
To Next Page
Loading...
