Figure 8-6 Cable connection detection
– When a user clicks Search for Device, cable connections (DC and AC) will be
checked before device search (not applicable to third-party devices), and device
address will be automatically allocated.
– After the cable connection check and device search are complete, if a cable
connection alarm is generated, you can click the alarm icon to view the
corresponding alarm information.
– If an alarm is generated when the cable connection check fails, click the alarm icon
to view the alarm cause and handling suggestions. After the fault is rectied,
check the cable connection again.
– After the cable connection check and device search are complete, click to view
the corresponding topology information.
– After a device is added or deleted, you need to click Search for Device again.
Otherwise, the system topology will not update.
3. Connect to the power meter.
Figure 8-7 Setting power meter parameters
4. Connect to the EMI.
LUNA2000-2.0MWH-1H0, 2H0 Smart String ESS
User Manual 8 SmartLogger Web-based Deployment
Issue 02 (2021-11-15) Copyright © Huawei Technologies Co., Ltd. 122
To Next Page
Loading...