Huawei LUNA2000-97KWH-1H1 - Page 180

NO TICE
● Ensure that the painting is thin, even, and smooth.
● In the case that an equipment pattern has dierent colors, to prevent
undamaged areas and those with dierent colors as the damaged area from
being contaminated during repainting, cover such areas using white paper and
adhesive tape before repairing paint.
Figure B-3 Repainting a damaged area
Step 5 Wait for 30 minutes and check whether the painting meets the requirements.
NO TE
● The color of the repainted area must be consistent with that of the surrounding area.
Use a colorimeter to measure the color dierence, which should be less than or equal to
3 (ΔE ≤ 3). If a colorimeter is unavailable, ensure that there is no visible edge between
the repainted area and the surrounding area. The paint should be free of bulges,
scratches, aking, or cracks.
● If you choose to spray paint, it is recommended that you spray paint three times before
checking the result. If the color does not meet the requirements, paint more times until
the painting meets the requirements.
----End
Paint Supply Information
Table B-2 Paint requirements
Item
Requirement
Primer thickness 60 μm
Intermediate coat thickness 120 μm
Top coat thickness 60 μm
Primer type Epoxy zinc-rich paint
Intermediate coat type Zinc-rich paint
LUNA2000-(97KWH-1H1, 129KWH-2H1,
161KWH-2H1, 200KWH-2H1) Smart String ESS
User Manual B How Do I Repair Paint Damage?
Issue 10 (2023-11-07) Copyright © Huawei Digital Power Technologies Co., Ltd. 170