1. Loosen the two screws on the panel and pull out the subrack slowly, as shown
in Figure 7-17.
Figure 7-17 Pulling out an enclosure
2. Loosen the two screws on the cover and remove the cover, as shown in Figure
7-18.
Figure 7-18 Removing a cover
3. Press the retention clips on ball bearing guide rails, pull out the system
subrack, and place the system subrack on the ESD table, as shown in Figure
7-19.
OceanStor V5 Series
Parts Replacement 7 Replacing FRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 154
To Next Page
Loading...
