Huawei OceanStor V5 Series - Page 177

but not away from the enclosure.) Attach the device information label to the
information plate. Then, push the information plate back to the enclosure.
Figure 7-33 Position of the information plate
You can attach the device information labels to both the front and back of the information
plate. The label content and positions must be the same as those on the replaced system
subrack. If a label has been attached to one side of the information plate, you only need to
attach the device information label with a QR code to the other side of the information
plate. Attaching the device information plate helps engineers easily identify and maintain
devices.
Step 8 Install the system subrack into the cabinet, as shown in Figure 7-34.
1. Slide the system subrack into the cabinet along guide rails.
2. Use M6 screws to
x the system subrack in the cabinet.
3. Ensure that the system subrack is horizontally installed and tightly screwed.
Figure 7-34 Installing a system subrack
Step 9 Connect cables to the system subrack and press the Power button to power on the
storage device.
Step 10 When the Power indicator is steady on, check whether the status of each
component is normal.
● If yes, the system subrack has been successfully installed.
● If no, cables are incorrectly connected, components are incorrectly installed, or
the newly installed system subrack is faulty.
Step 11
Conrm the replacement.
OceanStor V5 Series
Parts Replacement 7 Replacing FRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 168