Step 4 Remove the management module, as shown in Figure 7-92.
1. Use the Phillips screwdriver to remove the two captive screws from the
management module.
2. Open the handles and pull out the management module.
Figure 7-92 Removing a management module
Step 5 Put the removed management module into an ESD bag.
Step 6 Take the spare part out of its ESD bag.
Step 7 Install the spare part, as shown in Figure 7-93.
1. Fully open the handles of the spare part, insert the spare part into the empty
slot, and close the handles.
2. Use the Phillips screwdriver to fasten the two captive screws on the
management module.
OceanStor V5 Series
Parts Replacement 7 Replacing FRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 242
To Next Page
Loading...
