Huawei OceanStor V5 Series

To Next Page

To Previous Page

Procedure

Step 1 Check status before replacement.

1. Check system status.

Start SmartKit and choose Home > Storage > Routine Maintenance >

Health Check. On the Health Check page, perform inspection as instructed.

For details, see 7.1.2 Checking System Status.

If any items fail the inspection, rectify the faults by performing the recommended

actions in the inspection reports. Ensure that all other parts except the parts to be

replaced are working properly.

2. Check the status of the parts to be replaced.

Start SmartKit and choose Home > Storage > Parts Replacement > Parts

Replacement. On the Parts Replacement page, click FRU Replacement.

Then complete the check before the replacement as prompted. For details, see

7.1.3 Replacing an FRU.

NO TICE

You can proceed to next steps only when all items pass the pre-replacement check

and the replacement page is displayed. If any item fails, rectify the fault as

prompted.

Step 2 Wear an ESD wrist strap.

Step 3 Remove cables connected to the data switch that you want to replace.

For the ground cable of the data switch, you only need to remove the end that connects to

the cabinet in this step. (The other end of the cable is secured to a side of the data switch

and will be removed after the data switch is removed from the cabinet.)

Step 4 Remove the data switch from its cabinet, as shown in Figure 7-95.

1. Use the Phillips screwdriver to remove the M6 screws from the data switch's

mounting ears.

2. Pull the data switch out of the cabinet along guide rails and place it on the

ESD table.

Figure 7-95 Removing a data switch

OceanStor V5 Series

Parts Replacement 7 Replacing FRUs

Huawei OceanStor V5 Series - Page 254