Huawei OceanStor V5 Series

To Next Page

To Previous Page

Figure 7-112 Installing a disk

3. Ensure that the ejector lever is fastened to the chassis beam, and lower the

ejector lever to completely insert the spare part into the chassis. See step (2)

in Figure 7-112.

Step 3 Wait until the disk indicator turns normal, indicating that the disk is powered on.

----End

Follow-up Procedure

1. Run the qsadmin command to check whether the

conguration page of the

quorum server software is displayed.

Q2qumrom:~ # qsadmin

start main!

Waiting for connecting to server...

admin:/>

– If the preceding command output is displayed, go to 2.

– If the preceding command output is not displayed, the arbitration

conguration information has been lost. In this case, reinstall and

congure the quorum server software.

For details, see the

BC&DR Solution Product Documentation (Active-Active

DCs)

2. Run the show server_ip command to check whether the connection between

the quorum server and storage devices is in Established state.

admin:/>show server_ip

Index Server IP Server Port

----- --------------- ---------------

1 192.168.6.31 30002

2 192.168.7.31 30002

Index Local IP Local Port Remote IP Remote Port State

----- --------------- --------------- --------------- --------------- ---------

0 192.168.6.31 30002 192.168.6.17 44510 Established

1 192.168.6.31 30002 192.168.6.18 36836 Established

2 192.168.7.31 30002 192.168.7.16 57416 Established

3 192.168.7.31 30002 192.168.7.28 49752 Established

– If yes, the quorum server can work properly.

– If no, check whether the IP address of the quorum server is correct.

OceanStor V5 Series

Parts Replacement 7 Replacing FRUs

Huawei OceanStor V5 Series - Page 266