Figure 8-12 Pushing open the handles
Step 4 Remove the MCB using the MCB extracting kit.
Install and remove MCBs using the MCB extracting kit. Do not install or remove
MCBs barehanded.
Figure 8-13 Removing the MCB
Step 5 Remove the copper bars on both ends of the old MCB, and install the copper bars
on a new MCB.
Verify that the new MCB is switched to OFF before the installation.
Figure 8-14 Removing copper bars on both ends of an MCB
PDU8000 Modular Precision PDC V2.0
User Manual 8 Maintenance Guide
Issue 04 (2021-04-13) Copyright © Huawei Technologies Co., Ltd. 128
To Next Page
Loading...
