Figure 5-40 Fill the holes with ake sealing putty
----End
5.4.4.2 Bottom Cable Routing
The following procedure applies to a single-input PDC.
Procedure
Step 1 Remove the transparent covers of the N bar and input copper bar, and put the
covers aside.
Figure 5-41 Removing the transparent covers of the N bar and input copper bar
Step 2 Connect the equipotential ground cables for the cabinet.
PDU8000 Modular Precision PDC V2.0
User Manual 5 Installation Guide
Issue 04 (2021-04-13) Copyright © Huawei Technologies Co., Ltd. 61
To Next Page
Loading...
