As the onsite conditions may vary, the following steps are for reference only. Onsite
installation personnel and technical engineers can decide whether to perform the steps
based on the actual situation.
5.3.1 Moving the PDC
Context
The PDC weighs about 400 kg. Take protective measures during movement to
prevent toppling and bumping.
Procedure
Step 1 Remove the two L-shaped brackets between the front and rear door sills of the
PDC and the pallet, as shown by (1) and (2) in Figure 5-1.
Figure 5-1 Removing L-shaped brackets
Step 2 Use diagonal pliers to cut o the binding straps securing the unloading ramps,
and take out the unloading ramps on both sides, as shown by (3) in Figure 5-1.
Step 3 Clip the unloading ramps to the wooden pallet.
PDU8000 Modular Precision PDC V2.0
User Manual 5 Installation Guide
Issue 04 (2021-04-13) Copyright © Huawei Technologies Co., Ltd. 38
To Next Page
Loading...
