Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server, and label its panel to prevent
misoperations.
Step 3 Power off the RH2288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the RH2288 V3 and put it on an ESD desktop. For details, see 3.6 Removing the
Server.
Step 6 Remove the chassis cover. For details, see 7.11 Removing the Chassis Cover.
Step 7 Remove the PCIe card from the mainboard. For details, see 7.21.2 Removing a PCIe Card
from the Mainboard.
Step 8 Loosen the screws that secure the rear hard disk module. See steps (1) and (2) in Figure
7-106.
Figure 7-106 Removing the rear hard disk module
Step 9 Raise the rear hard disk module to remove it. See step (3) in Figure 7-106.
Step 10 Determine the position of the SD card to be removed. See Figure 7-107.
SD card 1 is above the SD card board, and SD card 2 is below the SD card board.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 224
To Next Page
Loading...
