Figure 7-112 Installing a SD card
3. Tighten the two screws. See step (2) in Figure 7-112.
NOTE
If the server has two microSD cards, RAID rebuild will be automatically performed after one of
the microSD cards is replaced. Perform subsequent operations only after the RAID rebuild is
complete.
Step 6 Place the rear hard disk module correctly, and tighten the screws to secure the module. See
steps (1) to (3) in Figure 7-113.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 230
To Next Page
Loading...
