Step 3 Take the spare rear disk backplane out of its ESD bag.
Step 4 Insert the rear disk backplane in the arrow direction until it does not move, and tighten the
screw to secure the rear disk backplane. See steps (1) and (2) in Figure 7-121.
Figure 7-121 Installing the rear disk backplane
Step 5 Install the rear hard disk module into the chassis and tighten the screws. See Figure 7-122.
Figure 7-122 Installing the rear hard disk module
Step 6 Connect cables to the rear disk backplane.
Figure 7-123 shows the cable connections to the rear disk backplane for all 3.5-inch hard
disks. Figure 7-124 shows the cable connections to the rear disk backplane for all 2.5-inch
hard disks. If the server uses both 3.5-inch and 2.5-inch hard disks, refer to Figure 7-123 and
Figure 7-124 for cable connections.
The ports with the same number are connected to each other.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 239
To Next Page
Loading...
