No
.
Description BOM Number
6 Signal cable for connecting the front disk
backplane (J1) to the mainboard (J1003)
04051052
7 Signal cable for connecting the USB plate of the
left mounting ear to the mainboard (J42)
04051006
8 Power cable for connecting the front disk
backplane (J24) to the mainboard (J30 PWR
CONN1)
04150997
NOTE
The silkscreen slot numbers for the standard PCIe cards of some models are Port 0 and Port 1, which
correspond to Port A and Port B respectively.
Table 2-10 shows the mapping between the slot numbers in the LSI Logic SAS BIOS CU and
the panel silkscreens when the RH2288 V3 is configured with a front 24-disk backplane and
two RAID controller cards.
Table 2-10 Mapping between the slot numbers in the LSI Logic SAS BIOS CU and the panel
silkscreens (2 RAID controller cards)
Adapter No. in the CU
Slot No. in the CU Panel Silkscreen
0 Slots 0–7 0–7
1 Slots 0–7 8–15
l (4) and (5) of Figure 2-27 show the cable connection of RAID controller card 0 (adapter
0).
l (2) and (3) of Figure 2-27 show the cable connection of RAID controller card 1 (adapter
1).
Internal Cabling for a Server with Three RAID Controller Cards
The RH2288 V3 does not support rear hard disks if it is configured with three RAID
controller cards, including two in standard PCIe slots and one on the mainboard.
RH2288 V3 Server
User Guide
2 Overview
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 47
To Next Page
Loading...
