l Bind optical cables with cable ties. Ensure that optical cables are routed straightly and
bound neatly and that cable ties are installed at even spacing and fastened properly.
Step 4 When you use an optical cable:
1. Remove the old optical cable.
Remove the old optical cable from the server.
2. Connect the new optical cable.
NOTE
l Connect the new optical cable to the same port as the old one.
l Connect the optical cable to the optical module securely.
1. Insert the optical module into the optical port. See step (1) in Figure 3-17.
Figure 3-17 Connecting an optical cable
2. Close the latch on the optical module to secure it. See step (2) in Figure 3-17.
3. Insert the optical cable into the optical module. See step (3) in Figure 3-17.
Step 5 When you use an SFP+ cable:
1. Remove the old SFP+ cable.
Gently push the power connector inwards and pull the latch out to remove the SFP+
cable. See Figure 3-18.
Do not directly pull the latch out.
RH2288 V3 Server
User Guide
3 Installing and Removing the Server
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 81
To Next Page
Loading...
