RMS-SNMP01A SNMP Card
User Manual
4 Managing the UPS on the WebUI
Copyright © Huawei Technologies Co., Ltd.
Figure 4-26 Modify User page
Idle Timeout Logout
You can set Allowed timeout (min), as shown in Figure 4-24. After the specified time, you
are logged out.
4.6.3 Site Config Page
On the Site Config page, set the system date, time, and time zone, and choose whether to
synchronize the Windows time, as shown in Figure 4-27. The SNMP card can synchronize
time from the NTP server using the RFC868, NTPv3, or RFC1305 protocol to the local time.
To enable this, specify a valid NTP server IP address and click Submit for the setting to take
effect, as shown in Figure 4-28. The SNMP card can also synchronize time from the
NetEco1000U. To enable this, select a valid NetEco1000U IP address from the address list
and click Submit for the setting to take effect, as shown in Figure 4-29.
You can set System name (ups2000 as default), System location (Not Configure System
Location as default), and Contact person (Not Configure System Contact as default) on the
WebUI.
The SNMP card supports Secure Sockets Layer (SSL) certificate import, as shown in Figure
4-30. The certificate is used for SSL encryption protection during WebUI login. Apply to a
third-party institution for the certificate.
To Next Page
Loading...
