Huawei SUN2000 MAP0 Series - Installation; Installation Modes; Installation Requirements; Site Selection Requirements

4 Installation
4.1 Installation Modes
The inverter can be wall-mounted or support-mounted.
Table 4-1 Installation modes
Installation
Mode
Screw Specications Description
Wall
mounting
M6x50 stainless steel expansion bolt Delivered with
the product
Support
mounting
M6 stainless steel bolt assembly Prepared by the
customer
4.2 Installation Requirements
4.2.1 Site Selection Requirements
Basic Requirements
● The inverter is protected to IP66 and can be installed indoors or outdoors.
● Do not install the inverter in a place where personnel are easy to come into
contact with its enclosure and heat sink, because these parts are hot during
operation.
● Do not install the inverter in noise-sensitive areas.
● Do not install the inverter near ammable or explosive materials.
● Keep the inverter out of reach of children.
● Do not install the inverter outdoors in salt-aected areas because it will be
corroded there and may cause re. A salt-aected area refers to a region
within 500 m of the coast or prone to sea breeze. Regions prone to sea breeze
SUN2000-(5K-12K)-MAP0 Series
User Manual 4 Installation
Issue 01 (2024-05-13) Copyright © Huawei Digital Power Technologies Co., Ltd. 27