Figure 4-10 Securing the mounting bracket
Step 4 (Optional) Install the DC switch locking screw.
● The DC switch locking screw is delivered with the inverter. According to the Australian
standard, the locking screw is used to lock the DC SWITCH to prevent the inverter from
being started by mistake.
● Perform this step for models used in Australia based on local standards.
Figure 4-11 Installing the DC switch locking screw
Step 5 Install the inverter on the mounting bracket.
Step 6 Tighten the bolt assemblies.
SUN2000-(12K-25K)-MB0 Series
User Manual 4 Installation
Issue 01 (2023-04-30) Copyright © Huawei Digital Power Technologies Co., Ltd. 33
To Next Page
Loading...
