UPS5000-A-30 kVA & 40 kVA & 80 kVA
User Manual
Copyright © Huawei Technologies Co., Ltd.
Figure 3-12 Assembling support bases
Step 2 Pull the back-end handle out of the UPS, as shown in Figure 3-13.
Figure 3-13 Pulling the back-end handle
1. Loosen the back-end handle screws anticlockwise.
2. Pull the handle out of the groove.
Step 3 Hold the front-end handle and back-end handle to place the UPS on support bases. Each UPS
requires two pairs of support bases, and the distance between the two pairs of support bases
must be 480 mm or more, as shown in Figure 3-14.
To Next Page
Loading...
