Huawei USG6000 - Page 122

Command Description Impact
undo ipv6 route-static track
bfd-session [ session-name
bfd-name ] admindown
invalid
The command deletes the
configured static routes.
None
display bgp ipv6 bfd session
{ [ vpnv6 vpn-instance vpn-
instance-name ] peer ipv6-
address | all }
The command displays
information about the BFD
session set up by BGP.
None
display bgp ipv6 bfd session
all [ vpnv6 vpn-instance
vpn-instance-name ]
The command displays
information about the BFD
session set up by BGP.
None
undo peer { ipv4-address |
ipv6-address } bfd block
The command restores a
peer to inherit the BFD
function from its peer group.
None
undo peer { group-name |
ipv4-address | ipv6-
address } bfd enable
The command prohibits a
peer from inheriting the
BFD function from its peer
group.
None
undo peer { group-name |
ipv4-address | ipv6-
address } bfd { min-tx-
interval min-tx-interval |
min-rx-interval min-rx-
interval | detect-multiplier
multiplier | wtr wtr-value } *
The command restores
default values of BFD
detection parameters.
None
peer { group-name | ipv4-
address | ipv6-address } bfd
enable [ single-hop-prefer ]
The command sets up a
BGP session for a peer or
peer group.
None
undo peer { group-name |
ipv4-address | ipv6-
address } bfd { min-tx-
interval | min-rx-interval |
detect-multiplier | wtr } *
The command restores
default values of BFD
detection parameters.
None
display ospfv3 [ process-id ]
bfd session [ interface-name
| interface-type interface-
number ] [ neighbor-id ]
[ verbose | all ]
The command displays
bidirectional forwarding
detection (BFD) session
information of all OSPFv3
processes.
None
bfd all-interfaces enable The command enables BFD
in the IS-IS process.
None
HUAWEI USG6000&USG9500
Upgrade Guide
2 USG9500
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
113