Huawei USG6000 - Page 160

NOTE
l Ensure that an activated license file is available. If the license file is not activated, the upgrade fails.
l Ensure that the device can access the security center directly or through a proxy server.
l Configure a security policy to permit HTTP and FTP packets when the device directly connects to
the security center or permit HTTP packets when the device connects to the security center through a
proxy server. For details, see the description of security policies and content security in
USG6000&USG9500 V500R001C80SPC100 Administrator Guide.
l Before executing the following online loading procedure, ensure that the DNS server address has
been configured and the DNS server can correctly parse http://sec.huawei.com.
l Upgrading V500R001 to V500R001C80SPC100.
1. Move the pointer to
on the lower right of the page and click to open
the CLI console. Click any space on the page. If the command prompt <FW> is
displayed, you can perform configurations on the CLI.
download module nextstartup
install-module CSG_H50010000_yyy.mod next-startup
install-module URLRMT_H50010000_yyy.mod next-startup
2. After the loading in either local or online mode, run the display module-information
verbose command to view details on the dynamically loaded component package. The
following information is a part of the command output. If the State value is
INSTALL_OK, the component packet has been successfully loaded.
<USG9500> display module-information verbose
Module
Information
------------------------------------------------------------------------
Module Version InstallTime
PackageName
------------------------------------------------------------------------
ConSecGroup 1.0.0.0 2015-12-23 11:13:37+00:00
CSG_H50010000_yyy.mod
URL Filter 1.0.0.0 2015-12-23 11:13:37+00:00
URLRMT_H50010000_yyy.mod
************************************************************************
* Content Security Group information, as follows:
*
************************************************************************
Slot Type State
Detail
------------------------------------------------------------------------
- NP INSTALL_OK -
************************************************************************
* URL Filter information , as follows:
*
************************************************************************
Slot Type State
Detail
------------------------------------------------------------------------
- NP INSTALL_OK -
…………………
Step 7 Choose System > Setup > Restart. Click Save and Restart to save the configurations and
restart the system. Or Click Restart not to save the configurations and restart the system.
HUAWEI USG6000&USG9500
Upgrade Guide
2 USG9500
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
151