Figure 2-9 Uploading file
NOTE
The file to be uploaded must end with suffix .txt. If a file with the same name exists in CF card 1,
the system displays a message to indicate whether to overwrite the original file.
After the file is successfully uploaded, return to the Master MPU License File Management
interface. The corresponding file is displayed in the list. You need to check whether the size of the
file in the list is the same as that on PC2. If no, re-upload the file.
Step 4 If both MPUs are present, perform the following operations to copy the file to the Slave MPU.
1. On the System Upgrade tab, click Select in the Slave MPU Next Startup System
Software, Slave MPU PAF File Management, Slave MPU License File Management
group box respectively. The Slave MPU Next Startup System Software, Slave MPU
PAF File Management, Slave MPU LicenseFile Management interface is displayed
respectively. Click
to select the file to be copied and enter the name of the target file. If no name is
entered, the name of the file to be copied is used as that of the new file. Click OK, as
shown in Figure 5.
Figure 2-10 Copying files from the master MPU to the Slave MPU
Step 5 On the System Software Management interface, click
corresponding to the uploaded file and configure the current file as the version software
used during next startup.
If both MPUs are present, respectively click
corresponding to the uploaded files on the
Main MPU System Software Management, Main MPU PAF File Management,Main
MPU License File Management and Slave MPU System Software Management, Slave
MPU PAF File Management, Slave MPU License File Managementinterfaces to configure
the current file as the version software used during next startup.
Step 6 (Optional) Upgrade sensitive features.
HUAWEI USG6000&USG9500
Upgrade Guide
2 USG9500
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
150
To Next Page
Loading...
