Huawei USG6000E Series - Page 207

Port Connector Type Description Available
Components
MGMT port RJ45 Out-of-band
10/100/1000M
RJ45 autosensing
Ethernet
management
port. The interface
number is METH
0/0/0 and the
default IP address
of the interface is
192.168.0.1.
You can connect
this port to the
network port or
any reachable
port on a PC
through a
network cable.
Then, you can use
Telnet to access
the CLI or use a
web browser to
access the web UI
to
congure,
manage, and
maintain the
device.
NOTE
The MGMT port
cannot be used as
a service port.
Ethernet Cable
Power Supply System
● Model whose BOM number does not contain "-001" or "-002": The power
supply system has one PAC600S12-B AC power module, but two power
modules can be
congured for 1+1 power redundancy.
● Model whose BOM number contain "-001" or "-002": The power supply
system has one PAC600S12-CB, PAC600S12-DB, or PAC600S12-EB AC power
module, but two power modules can be
congured for 1+1 power
redundancy.
Heat Dissipation System
The heat dissipation system consists of three FAN-023A-B modules working in 2+1
backup mode. From the front panel, the device provides a front-to-rear air
ow.
The fan module locates at the air exhaust of the system.
HUAWEI USG6000E Series
Hardware Guide 4 Hardware Overview
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 200