Huawei USG6000E Series - 5.3.1.2 Mounting a Device on a Workbench

----End
Follow-up Procedure
Perform the following checks after the installation:
● Ensure that the USG is placed securely inside the cabinet.
● Ensure that the exhaust of the USG is not blocked by other objects.
5.3.1.2 Mounting a Device on a Workbench
If you do not have a cabinet, you can mount the USG6510E, USG6510E-POE,
USG6530E on a workbench.
Precautions
Before unpacking the carton, ensure that the packing carton is intact and not
damaged or soaked. Stop unpacking if the USG is rusted or soggy. Then,
investigate causes and contact the supplier.
The workbench must be:
● Reliably grounded.
● Clean,
rm, and securely installed.
Accessories
Four rubber feet
Procedure
Step 1 Fix the rubber feet to the round notches at the bottom of the USG.
NO TE
Install foot pads at the bottom of the USG to ensure smooth contact between the USG and
the workbench and avoid friction between the surface of the USG and the workbench.
Step 2 Place the USG on the workbench.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 515