Huawei USG6000E Series - 5.3.2 Connecting a PGND Cable

Figure 5-10 Mounting the USG on a wall
----End
Follow-up Procedure
After wall-mounting is complete, verify that:
● The USG is securely
xed on the wall.
● A clearance of 10 cm is maintained around the USG and the air
ow is not
blocked.
5.3.2 Connecting a PGND Cable
Connecting the PGND cable of a USG6510E, USG6510E-POE, USG6530E correctly
is a key measure of surge protection and resistance to interference. Before using
the USG6510E, USG6510E-POE, USG6530E, correctly connect the PGND cable.
Otherwise, the USG may be damaged.
Precautions
The USG has been installed inside a cabinet.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 520