Huawei USG6000E Series - 5.5.5 Installing Optical Transceivers and Connecting Optical Fibers

Step 4 Remove the temporary labels and attach labels (2 cm away from the connectors)
at both ends of the console cable.
----End
Follow-up Procedure
After the cable connection is complete, verify that:
● The labels at both ends of a cable are correct, clear, neat, and facing the same
direction.
● Cables and connectors are free of damage or breakage and are connected
properly.
For details on the console login, refer to the
Conguration Guide.
5.5.5 Installing Optical Transceivers and Connecting Optical
Fibers
This section describes how to install optical transceivers on the 10GE, 40GE, 100GE
optical ports of the USG and connect them to the ports of the peer device using
optical bers according to the network plan.
Context
The USG supports 1 Gbit/s, 10 Gbit/s, 40 Gbit/s, 100 Gbit/s optical modules. The
optical modules at both ends are the same, including the optical
ber type
(single-mode or multi-mode), optical ber connector type (LC/PC, SC/PC, FC/PC,
or MPO/PC-MPO/PC), and transmission rate. If
dierent optical modules are used
at the two ends, the communication may fail.
NO TICE
Huawei optical modules are recommended. The optical modules from other
vendors may cause faults on the USG due to incompatibility.
CA UTION
Do not look into the optical interface of the optical module or the optical ber
connector without eye protection.
Before connecting optical ber cables, read the following precautions:
● Do not overbend optical bers, and the radius should not be shorter than 40
mm.
● Do not bundle the optical
bers too tight. Otherwise, the transmission
performance of the optical bers and the communication between devices
might be adversely
aected.
Before connecting optical ensure the following:
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 573