Huawei USG6000E Series - Page 581

● The optical module has been installed.
Procedure
Step 1 Insert an optical transceiver into the 10GE, or 40GE, or 100GE optical port of the
USG.
Step 2 Remove the dust cap from the optical transceiver.
NO TE
Set aside the dust cap properly for future use. After optical ber are disconnected for
maintenance, use the dust cap to prevent the optical transceiver from dust.
Step 3 Before connecting an optical ber, attach temporary labels to both ends of the
optical
ber for identication.
Step 4 Remove protective caps from optical ber connectors, insert optical bers into the
optical transceiver, and connect the ber to the peer device.
NO TE
Ensure that the Tx and Rx ports are correctly connected.
Ensure that the TX and RX ports on one end of the optical ber cable are
connected to the RX and TX ports (respectively) on the other end.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 574