Figure 5-49 Installing optical transceivers and connecting optical bers
Step 5 Repeat Step 1 to Step 4 to install all optical transceivers and connect all optical
bers.
----End
Follow-up Procedure
After you power on the USG, check the connection by observing the optical port
indicator. If the indicator is on or blinks, the link is connected or data is being
transmitted. If the indicator is
o, the link is disconnected. Possible causes for the
disconnection are as follows:
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 575
To Next Page
Loading...
