Huawei USG6000E Series - 4.6.2 AC Power Cable; 4.6.2.1 AC Power Cable

Technical Specications
Table 4-302 Technical specications of the PGND Cable
Descriptio
n
Part
Number
Model Connector
X1
Connector
X2
Cable
length
Power
Cable,0.4m,
4mm^2,OT
6-4,227IEC
02-4^2G&Y
,OT6-6
04150617 IEC401 14170017:
OT2-16-8
14170023:
OT6-6
0.4 m
Power
Cable,
4m,OT2-16
-8,H07Z-
K-16^2G&Y
,OT16-6,LS
ZH
04152748-
001
- OT2-16-8 OT16-6 0.85 m
4.6.2 AC Power Cable
4.6.2.1 AC Power Cable
Connection
An AC power cable is connected as follows:
● The C7 straight female or C13 straight female connector is connected to the
AC power socket of the USG.
● The PI straight male, PB straight male, PD angle male, or PG angle male
connector is connected to an external power source.
Use a single-phase 3-line electrical outlet that has been properly grounded. The
grounding point of the power supply must be reliably grounded in the building.
Generally, the grounding point of the power supply system of the building has
been buried in the grounding during the construction and wiring of the building.
NO TICE
Make sure that the power system of the building has been grounded before you
connect the USG with AC power cables.
HUAWEI USG6000E Series
Hardware Guide 4 Hardware Overview
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 473