Huawei USG6000E Series - 4.6.5 Ethernet Cable; 4.6.5.1 Ethernet Cable

Table 4-307 Technical specications of the console cable
Item Description
Connector 1 DB9 connector - D model - 9PIN - female
Connector 2 RJ45 Network Interface Connector, Crystal Connector, 8PIN,
8BIT, Shielded, Plug
Cable Single Cable, Console Serial Port Cable, 3 m, D9F,
CC4P0.48B(S), MP8-VI
Wire 8
4.6.5 Ethernet Cable
4.6.5.1 Ethernet Cable
Connection
The Ethernet cable, also called the network cable, is used for carrying signals on
Gigabit networks or networks with a lower packet rate.
Ethernet cables are
classied into straight-through and crossover cables according
to the wiring scheme used at the two ends of the cables. The interfaces of the
USG can dynamically adapt to straight-through cables and crossover cables.
NO TICE
Figure 4-190 and Figure 4-191 show how to distinguish and make straight-
through cables and crossover cables. You need to strictly observe the wiring
scheme to ensure the quality of services.
● Straight-through cable
The straight-through cable is also called the standard cable. Both ends of the
cable use wiring scheme EIA/TIA T568A or EIA/TIA T568B. You are advised to
use wiring scheme EIA/TIA T568B when you make straight-through cables.
Figure 4-190 shows the detail.
HUAWEI USG6000E Series
Hardware Guide 4 Hardware Overview
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 491