Huawei USG6000E Series - 5.4.4 Connecting a Console Cable

Figure 5-29 Installing a hard disk (USG6575E-B, USG6605E-B, USG6610E,
USG6615E, USG6620E, USG6625E, USG6630E, USG6635E, USG6650E, USG6655E)
Step 3 After the ejector lever of the hard disk is fastened to the chassis, close the hard
disk ejector lever.
Step 4 After the installation is complete, perform the following operations:
NO TE
Operations after the USG power-on must be performed after all installation tasks are
complete.
● Before the USG is powered on, ensure that the hard disk is correctly installed.
● After the USG is powered on, run the display disk information command in
the user view to check whether the Filesystem Status value is Mounted.
----End
5.4.4 Connecting a Console Cable
After connecting a PC to the console port of a USG6515E, USG6525E, USG6550E,
USG6555E, USG6560E, USG6565E, USG6575E-B, USG6580E, USG6585E,
USG6605E-B, USG6610E, USG6615E, USG6620E, USG6625E, USG6630E,
USG6635E, USG6650E, USG6655E with a console cable, you can use the terminal
emulation program on the PC to access the command
conguration interface of
the USG6515E, USG6525E, USG6550E, USG6555E, USG6560E, USG6565E,
USG6575E-B, USG6580E, USG6585E, USG6605E-B, USG6610E, USG6615E,
USG6620E, USG6625E, USG6630E, USG6635E, USG6650E, USG6655E.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 549