Huawei USG6000E Series - Page 555

NO TE
Operations after the USG power-on must be performed after all installation tasks are
complete.
● Before the USG is powered on, ensure that the hard disk is correctly installed.
● After the USG is powered on, run the display disk information command in
the user view to check whether the Filesystem Status value is Mounted.
----End
Installing The Hard Disk (USG6575E-B, USG6605E-B, USG6610E, USG6615E,
USG6620E, USG6625E, USG6630E, USG6635E, USG6650E, USG6655E)
Step 1 Remove the
ller panel from a hard disk slot.
Figure 5-28 Removing the
ller panel from a hard disk slot (USG6575E-B,
USG6605E-B, USG6610E, USG6615E, USG6620E, USG6625E, USG6630E,
USG6635E, USG6650E, USG6655E)
Step 2 Pull the ejector lever on the hard disk holder, keep it in pulled-out state, and push
the hard disk holder with two hands along the guide rails of the slot till the front
surface of the hard disk holder touches the USG panel.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 548