Huawei USG6000E Series - Page 554

● Wear an ESD wrist strap to protect the USG and hard disks from electrostatic
damage.
● Hold the two side surfaces of a hard disk, do not touch the PCB board or
squeeze the hard disk, and do not vibrate, bump, or stack hard disks.
● For mapping relationships between the USG and hard disks, see Hardware
Overview.
Tool
ESD bag
Installing The Hard Disk (USG6515E, USG6525E, USG6550E, USG6555E,
USG6560E, USG6565E, USG6580E, USG6585E)
Step 1 Remove the
bae plate from the hard disk slot.
Step 2 Hold the handlers of the hard disk and push the hard disk along the guide rails till
the hard disk aligns with the panel of the USG.
Step 3 Press the hard disk handler inwardly to restore the module.
Figure 5-27 Installing the hard disk (USG6515E, USG6525E, USG6550E,
USG6555E, USG6560E, USG6565E, USG6580E, USG6585E)
Step 4 After the installation is complete, perform the following operations:
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 547