Huawei USG6000E Series - 6.2 Replacing a Power Module

Figure 6-2 Removing the hard disk (USG6575E-B, USG6605E-B, USG6610E,
USG6615E, USG6620E, USG6625E, USG6630E, USG6635E, USG6650E,
USG6655E, USG6680E, USG6712E, USG6716E)
Step 3 Install the new hard disk, see Installing a Hard Disk.
Step 4 Run the disk online command in the system view and then the display disk
information command. If Filesystem Status is Mounted, the hard disk works
properly.
----End
Follow-up Procedure
After replacing the hard disk, collect all tools. If the replaced hard disk is faulty,
ll
in the Repair Transmission Sheet and send the faulty module with the Repair
Transmission Sheet to the equipment supplier or the
specied repair service
provider.
6.2 Replacing a Power Module
This section describes how to replace a faulty power module.
Context
When two power modules are installed on the USG, one of them is hot
swappable. Pay attention to the following items during hot swapping:
HUAWEI USG6000E Series
Hardware Guide 6 Maintaining the Hardware
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 583