Huawei USG6000E Series - 5.5.3 Installing a Hard Disk

To Next Page

To Previous Page

● The electrical resistance between the ground terminal and ground point is less

than 0.1 ohm on a multimeter.

5.5.3 Installing a Hard Disk

This section describes how to install a hard disk units for the rst time to avoid

hard disk damage.

Precautions

Precautions for the use of hard disks

● Use Huawei hard disks. The system cannot recognize the hard disks provided

by other vendors.

● Wear an ESD wrist strap to protect the USG and hard disks from electrostatic

damage.

● Hold the two side surfaces of a hard disk, do not touch the PCB board or

squeeze the hard disk, and do not vibrate, bump, or stack hard disks.

● For mapping relationships between the USG and hard disks, see Hardware

Overview.

Tool

ESD bag

Procedure

Step 1 Remove the

ller panel from a hard disk slot.

Figure 5-46 Removing the ller panel from a hard disk slot

HUAWEI USG6000E Series

Hardware Guide 5 Hardware Installation

Other manuals for Huawei USG6000E Series