Huawei USG6000E Series - Page 322

Port Connector Type Description Available
Components
MGMT port RJ45 Out-of-band
10/100/1000M
RJ45 autosensing
Ethernet
management
port. The interface
number is METH
0/0/0 and the
default IP address
of the interface is
192.168.0.1.
You can connect
this port to the
network port or
any reachable
port on a PC
through a
network cable.
Then, you can use
Telnet to access
the CLI or use a
web browser to
access the web UI
to
congure,
manage, and
maintain the
device.
NOTE
The MGMT port
cannot be used as
a service port.
Ethernet Cable
Power Supply System
● Early delivery: The power supply system has two PAC1K2S12-B AC power
modules for 1+1 power redundancy.
● Later delivery: The power supply system has two PAC1K2S12-CB AC power
modules for 1+1 power redundancy.
Heat Dissipation System
The heat dissipation system consists of four FAN-036A-B modules working in 3+1
backup mode. From the front panel, the device provides a front-to-rear air
ow.
The fan module locates at the air exhaust of the system.
HUAWEI USG6000E Series
Hardware Guide 4 Hardware Overview
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 315