Category Instrument/Meter
Drilling tools ● Hammer drill: used to drill mounting holes during wall-
mounting.
● Vacuum cleaner: used to remove dust and debris
produced while drilling holes.
● Hammer: used to drive the hollow wall anchors into
mounting holes.
Pliers ● Needle-nose pliers: used to hold small ttings and twist
ne wires in a narrow workplace.
● Diagonal cutting pliers: used to cut insulated sleeves
and tie wraps.
Auxiliary tools ● Knife: used to peel the insulated sleeve from the cable.
● Ladder: used to access overhead cabling.
Special tools ● Wire stripper: used to peel the insulated sleeve of the
communication cable.
● RJ-45 crimping tool: used to crimp RJ-45 cables for
telephony and Ethernet applications.
● Crimping tool: used to crimp the metal sleeve at the
ends of coaxial cables.
● Floating nut mounting bar: used to install
oating nuts
to the mounting bars of the cabinet.
● ESD gloves: used to protect the device from being
damaged by static electricity.
● ESD wrist strip: used to protect the device from being
damaged by static electricity.
● Protective gloves: used to shield hands from being
injury by sharp objects.
Meters ● Network cable tester: used to test whether a network
cable is connected and check the connection sequence
in a network cable.
● Optical power meter: used to test the optical power.
● Optical attenuator: used to measure optical
attenuation.
● Multimeter: used to test insulation within the cabinet,
cable connections, and electric performance
specications of the device, such as the voltage,
current, and resistance.
● Ground resistance tester: used to measure the ground
resistance.
●
Conguration terminal (A common PC is also
applicable).
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 511
To Next Page
Loading...
