Precautions
Before unpacking the carton, ensure that the packing carton is intact and not
damaged or soaked. Stop unpacking if the USG is rusted or soggy. Then,
investigate causes and contact the supplier.
Tools and Accessories
● Ruler
● Marker
● Hammer drill
● Vacuum cleaner
● Hammer
● Phillips screwdriver
● Mounting ears and matching screw (purchased separately, BOM numbers:
21240477)
Procedure
Step 1 Fix mounting ears to both sides of the panel with ports using M4 screws.
Figure 5-7 Installing the mounting ears on the chassis
Step 2 Determine the locations of four mounting holes on the wall using a ruler and
mark the mounting holes with a marker.
● The wall must be a bearing wall. Otherwise, the wall is not suitable for wall-mounting.
● Ensure that the height of mounting holes is proper so that the indicators are easy to
view.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 517
To Next Page
Loading...
