Huawei USG6000E Series - Page 530

SD card model is SDSDQAE-064G, the capacity is 64 GB, and dimensions (H x
W x D) are 1 mm x 15 mm x 11 mm (0.04 in. x 0.59 in. x 0.43 in.).
● The micro SD card can be installed no matter the device is powered o or the
device is running. The installation methods are the same. In this section, the
micro SD card is installed when the device is powered o.
● To replace the micro SD card when the USG is powered on, you must run the
sd-card oine command in the system view rst. After the system displays a
message indicating that the micro SD card is oine, remove the micro SD
card. Otherwise, the micro SD card might be damaged, and the data may be
lost. For details, see Replacing a Micro SD Card (USG6510E, USG6510E-
POE, USG6530E).
● Make sure that you have worn an ESD wrist strap and the strap is well
grounded before you hold the micro SD card. Otherwise, the micro SD card
may be damaged.
Tools
● Phillips screwdriver
● ESD wrist strap
Procedure
Step 1 Determine the slot (the slot with a "micro SD" mark on the rear panel) for
installing the micro SD card.
Step 2 Install the micro SD card and anti-theft board.
NO TE
● Note that the micro SD card must be installed with the face with words upwards.
● Do not use too much force; otherwise the micro SD or micro SD card slot might be
damaged.
1. Insert the micro SD along the guide rail to the micro SD card slot.
2. When you hear a click, the micro SD card is in position.
3. Hook the locating hook on the anti-theft board to the locating hole of the
rear panel and tighten the captive screw on the anti-theft board.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 523